Home VGA-Umschalter ST to VGA ST to SCART
 

18.9.4 ST MONO to VGA


ST MONO output to VGA Display


After a lot of digging around in magazine back-issues and some hardware books, atari manuals, i found some following informations. Here are the connection details for an ST(e) to VGA monitor:


Tabelle 118: ST Computer to VGA Display
ST pin number Color/Signal VGA pin number Color/Signal
7 Red 1 Red
6 Green 2 Green
10 Blue 3 Blue
9 H Sync 13 H Sync
12 V Sync 14 V Sync
13 GND 10 GND
13 GND 6 Red Return
13 GND 7 Green Return
13 GND 8 Blue Return
13 GND 10 GND
13 GND 11 GND


Note:
To work in this mode, the monitor must be able to operate at a line frequency of 15.5 KHz. Other modes won't work. This schematic works for ST low, and med mode.
If you like to use ST Mono (ST high mode) out as Video signal, watch the following schematic.
Note:
This only works as monocrome!
Your display must handle a refesh rate of 71Hz!



Abbildung 1 - ST to VGA as MONOCROME only Display








Copyright © Robert Schaffner (doit@doitarchive.de)
Letzte Aktualisierung am 23. Mai 2004
Home VGA-Umschalter ST to VGA ST to SCART